Apr 6 2021
3D Printing
Still loving my Ender 3, although at this point it has been highly modified. I did find one issue, that is 100% my fault. I had the current for the stepper motors turned up way too high so it was overheating the motors and causing the gantry to drop during prints. Once I fixed that issue it is back to printing well. I still need to add some thermal compound between the heartbreak & heatsink I swapped to (a Mellow NF Smart CR10) but given my normal printing temps it isn’t too bad.
Apr 22 2021
SkeeRide
I am still working on 3D printing my SkeeRide RC Snowmobile. Getting to the final amount of items to print though. Currently working on the front cover, then I have the tail light housing & side covers left. Unless I decide to go with a mod bumper that helps reinforce the rear suspension mounts. At any rate, enjoy this OctoLapse of the seat base print.
By Shaun • 3D Printing, RC 0