Apr 22 2021
I am still working on 3D printing my SkeeRide RC Snowmobile. Getting to the final amount of items to print though. Currently working on the front cover, then I have the tail light housing & side covers left. Unless I decide to go with a mod bumper that helps reinforce the rear suspension mounts. At any rate, enjoy this OctoLapse of the seat base print.
Apr 15 2021
Currently Minnesota is experiencing some massive temperature swings. All I can say is I really wish the weather would stabilize so my wife and I would stop getting migraines. I had to leave work early yesterday due to one and it sucks 
Apr 6 2021
Still loving my Ender 3, although at this point it has been highly modified. I did find one issue, that is 100% my fault. I had the current for the stepper motors turned up way too high so it was overheating the motors and causing the gantry to drop during prints. Once I fixed that issue it is back to printing well. I still need to add some thermal compound between the heartbreak & heatsink I swapped to (a Mellow NF Smart CR10) but given my normal printing temps it isn’t too bad.
Apr 23 2021
SkeeRide
Finished the front cover for my SkeeRide, at 31 hours it is the longest print I have done so far.
By Shaun • Uncategorized 0